Fujitsu ETERNUS CS800 - Page 165

Figure 112: OST Wizard: Add Storage Servers
Step 3: Add LSUs
1. Enter information about the LSU (see "OST Wizard: Add LSUs" on page 166).
Storage
Server
Select the storage server that will contain the new LSU.
Use
Available
Capacity
Select this option to add an LSU that uses the available capacity on the
system.
You cannot add an available capacity LSU to a storage server that already
contains an LSU. Also, if you add an available capacity LSU to a storage
server, you cannot add additional LSUs to that same storage server.
After you add an LSU that uses the Available Capacity option, you
cannot change the LSU to use the Specific Capacity option. Instead,
you must delete the LSU, then add a new LSU and choose the
Specific Capacity option (see "Deleting an LSU" on page 258).
Specify
Capacity
Select this option to specify the physical capacity of the LSU, and then
enter the following information.
l LSU Name - Enter the name of the LSU.
l Physical Capacity - Enter the physical capacity of the LSU (1 to
1048576 GB).
2. Click Add.
The LSU displays in the LSUs Added table.
ETERNUS CS800 165
8 Configuration Wizards