Fujitsu ETERNUS CS800 - Page 170

8.5 Replication Wizard
Step 1: About
1. Read the information about the wizard.
2. Click Next to continue.
At any time while using the wizard, you can click Previous to return to the
previous step.
Figure 117: Replication Wizard: About
Step 2: System
1. If data on this ETERNUS CS800 will be replicated to another ETERNUS CS800
system, enter target information under Target (see "Replication Wizard: System" on
page 172).
If two targets are already specified, you must delete a target before adding another. First
click Pause to pause replication to the target, and then click Delete to remove the target.
Before specifying a target, make sure you have completed the Replication wizard on
the target ETERNUS CS800. The target ETERNUS CS800 must be configured to allow
the source ETERNUS CS800 hostname or IP address.
You can specify up to two targets:
a. In the Target Hostname or IP Address box, enter the hostname or IP address of
the system that will receive the replicated data.
When entering IP addresses, never use an address that is in a reserved IP address
range. To see a list of reserved IP address ranges, click the quick tip icon [?] located
near the IP address field.
To use hostname format, you must specify at least one DNS IP address on the
Network page (see "Network" on page 319).
b. (Optional) Select an encryption option:
170 ETERNUS CS800