3. To configure the partition to receive replicated data from another ETERNUS CS800
system, enter the following information under Receive:
a. (Optional) Select the Enable Cartridge based replication to this ETERNUS
CS800 check box to enable Cartridge Based Replication for the partition, and then
enter a Sync ID in the box.
The Sync ID is used to identify the source partition that will send replicated data to
the target partition. The Sync ID must be identical to the Sync ID of the source
partition on the source system.
b. If you enabled Cartridge Based Replication, select an Access option:
Locked The partition is not allowed to receive new Cartridge Based Replication
data.
Unlocked The partition is allowed to receive new Cartridge Based Replication
data.
You cannot configure a partition to both send and receive Cartridge Based
Replication data.
4. Click Apply.
5. (Optional) To configure additional partitions for replication, repeat Steps 1–4.
6. Click Next to continue.
Figure 120: Replication Wizard: VTL Partitions
ETERNUS CS800 175
8 Configuration Wizards
To Next Page
Loading...
