Fujitsu ETERNUS CS800 - Page 174

8.5 Replication Wizard
Figure 119: Replication Wizard: NAS Shares
Step 4: VTL Partition
1. Select a VTL partition in the Replication Settings for VTL Partitions section to
manage its replication settings (see "Replication Wizard: VTL Partitions" on page
175).For help adding VTL partitions to the system, use the VTL Configuration Wizard
(see "VTL Wizard" on page 155).
2. To configure the partition to replicate its data to another ETERNUS CS800 system,
enter the following information under Send:
a. Select the Enable replication for selected partition check box to enable
replication for the partition.
b. (Optional) Select the Enable Cartridge based replication to target check box to
enable Cartridge Based Replication for the partition, and then enter a Sync ID in the
box.
With Cartridge Based Replication, a cartridge is automatically replicated when it is
unmounted. After replication, the replicated cartridges are immediately available on
the target system.
The Sync ID is used to identify the target partition that will receive replicated data
from the source partition. The Sync ID must be identical to the Sync ID of the target
partition on the target system.
c. Select the check box for each replication target you want to replicate the partition to.
When the partition is replicated, its data will be sent to all selected targets.
174 ETERNUS CS800