With Directory/File Based Replication, a file is automatically replicated when it is
closed or a period of time after it is modified. After replication, the replicated files are
immediately available on the target system.
The Sync ID is used to identify the target share that will receive replicated data from
the source share. The Sync ID must be identical to the Sync ID of the target share
on the target system.
c. Select the check box for each replication target you want to replicate the share to.
When the share is replicated, its data will be sent to all selected targets.
3. To configure the share to receive replicated data from another ETERNUS CS800
system, enter the following information under Receive:
a. (Optional) Select the Enable Directory/File based replication to this ETERNUS
CS800 check box to enable Directory/File Based Replication for the share, and then
enter a Sync ID in the box.
The Sync ID is used to identify the source share that will send replicated data to the
target share. The Sync ID must be identical to the Sync ID of the source share on
the source system.
b. If you enabled Directory/File Based Replication, select an Access option:
Locked The share is not allowed to receive new Directory/File Based
Replication data.
Unlocked The share is allowed to receive new Directory/File Based Replication
data.
You cannot configure a share to both send and receive Directory/File
Based Replication data.
4. Click Apply.
5. (Optional) To configure additional shares for replication, repeat Steps 1–4.
6. Click Next to continue.
ETERNUS CS800 173
8 Configuration Wizards
To Next Page
Loading...
