1. Enter the proxy server information:
l Server - Enter the IP address of the proxy server.
l Port - Enter the port number of the proxy server.
l Authentication Enabled - Select the check box if the proxy server requires
authentication.
l NTLM Authentication Enabled - Select the check box if the proxy server
requires NTLM (NT LAN Manager) authentication.
l Username - Enter the username to use for proxy authentication.
l Password - Enter the password to use for proxy authentication.
l Country - Select the country where the ETERNUS CS800 is located.
2. Click Next.
Figure 127: AISConnect Wizard: Proxy
Step 3: Confirm
After you have confirmed all settings, click OK. The wizard configures the ETERNUS
CS800 with the settings you selected.
ETERNUS CS800 183
8 Configuration Wizards
To Next Page
Loading...
