7. In the Destination Location drop-down box, select the type of location you want to
move the cartridge to (Drive, Storage Slot, I/E Slot).
8. Select the destination location to move the cartridge to.
The destination section displays empty drives, storage slots, and I/E slots.
Offline drives are not displayed. A drive might be offline if it has not been
mapped to a host (see "Remote Host Access" on page 233).
9. Click Apply.
10. Return the partition to an online state (see "Changing Partition Mode" on page 224).
Media Unload
Use the Media Unload page to perform a bulk unload of virtual tape cartridges from drives or
I/E slots.
If you do not create and associate a host access group with a partition, the virtual
devices are not visible from the host, and drives cannot be destinations for move
operations (see "Remote Host Access" on page 233).
CAUTION!
If you unload a virtual tape cartridge from a drive while a backup to that drive is in
progress, the backup job will fail.
To access the Media Unload page, on the Media page, click the Unload tab (see "Media
Unload Page" on page 232).
ETERNUS CS800 231
10 Configuration
To Next Page
Loading...
