Fujitsu ETERNUS CS800 - Page 272

10.5 Replication Configuration
Target System List
The Target list displays the following information for each target ETERNUS CS800:
Target The IP address of the target system that the ETERNUS CS800 is configured
to send data to.
Status The replication status of the ETERNUS CS800. For a detailed description of
all possible replication statuses, see "Replication" on page 363.
Source IP The IP address that is used to uniquely identify the source ETERNUS CS800
to the target.
Encryption The type of encryption used when sending replicated data to the target system
(None, 128-bit, or 256-bit).
Original
Data Size
The original, native size of data sent during replication or failback. This value
does not represent the amount of data actually sent over the network during
replication or failback because data is deduplicated and compressed before
being sent.
Actual
Data Sent
The amount of data actually sent over the network during replication or
failback. This value is usually much less than the Original Data Size due to
the benefits of data deduplication and compression.
Average
Send Rate
The average send rate (e.g. MB/s) of data sent over the network during
replication or failback (Actual Data Sent divided by the amount of time
required to complete replication or failback).
You can customize the appearance of the Target System list in the following ways:
l Click the top banner row of the list to collapse or expand the list.
l Click the arrow to the right of a column heading and select Sort Ascending or Sort
Descending to sort the rows in the table by that column.
l To show or hide a column, click the arrow to the right of a column heading, and then click
Columns. Select the check box to show a column, or clear the check box to hide a
column.
The statistics in the Target System list are for each target ETERNUS CS800
rather than a cumulative total for all targets as is displayed on the Home page.
Adding a Replication Target
Add a replication target to configure the ETERNUS CS800 to send replicated data to that
target. You can add up to two targets. After you add a target, you can enable replication to
that target for a NAS share or VTL partition. When replication is enabled for a share or
partition, replicated data is sent to the target system during scheduled or manual replication.
272 ETERNUS CS800