you must specify a NAT IP address for the ETERNUS CS800 on the Network page (see
"Configuring Interface IP Addresses" on page 326).
To access the Replication Configuration page, click the Configuration menu, and then
click the Replication tab (see "Replication Configuration Page" on page 271).
Figure 177: Replication Configuration Page
Tasks
Use the Replication Configuration page to perform the following tasks:
l View information about configured replication target systems (see "Target System List"
on page 272).
l Add, edit, or delete a replication target (see "Adding a Replication Target" on page
272,"Editing a Replication Target" on page 274, or "Deleting a Replication Target" on
page 276).
l Pause or resume replication to a target (see "Pausing or Resuming Replication to a
Target" on page 276).
l Configure a constant replication throttle (see "Enabling System Throttling" on page 276).
l View information about allowed replication source systems (see "Source ETERNUS
CS800 List" on page 278).
l Add or delete an allowed replication source (see "Adding a Replication Source" on page
278 or "Deleting a Replication Source" on page 279).
l Specify the maximum number of received snapshots to retain for each source (see
"Changing the Maximum Number of Snapshots" on page 279).
ETERNUS CS800 271
10 Configuration
To Next Page
Loading...
