Fujitsu ETERNUS CS800 - Page 312

10.8 Notifications
IP Address /
Network Mask
Result
10.40.166.87
10.40.166.0
Invalid because the logical bitwise operation (address AND mask)
is not equal to the address
10.40.166.87
255.255.0.0
Invalid because the logical bitwise operation (address AND mask)
is not equal to the address
10.40.0.0
255.255.0.0
Allows access from any client with address 10.40.xx.xx
Additional Information
l If you define a single community and set both the IP address and network mask to
0.0.0.0 (or leave both blank), then IP address-based access control is disabled. In
this case, the SNMP agent is accessible from any IP address.
l When entering IP addresses, never use an address that is in a reserved IP address
range. To see a list of reserved IP address ranges, click the quick tip icon [?] located
near the IP address field.
4. In the Access Type drop-down box, select the access type for the community:
Get Allows SNMP get operations.
Get/Set Allows both SNMP get and put operations.
5. Select the Community status check box to enable the community.
Or clear the Community status check box to disable the community.
6. Click Apply.
Editing a Community
Edit an SNMP community to change the IP address or access type for the community. You
can also enable or disable the community.
To edit a community:
1. Select SNMP destination and click Edit.
The Edit SNMP Community page displays (see "Edit SNMP Community Page" on
page 313).
312 ETERNUS CS800