Fujitsu ETERNUS CS800 - Page 311

Adding a Community
Add an SNMP community to include the ETERNUS CS800 in a group of devices that are
monitored by a common management station.
If no communities are defined, the SNMP agent is not accessible.
To add a community:
1. Click Add.
The Add SNMP Community page displays (see "Add SNMP Community Page" on
page 311).
Figure 199: Add SNMP Community Page
2. In the Name box, enter a unique Name for the community (up to 20 characters).
Valid characters are letters, numbers, hyphens, and underscores.
3. Enter a valid IP Address and Network Mask pair.
A pair is valid if performing a logical bitwise AND operation on the IP address and the
network mask results in the IP address. See the table below for examples:
IP Address /
Network Mask
Result
10.40.166.87
255.255.255.255
Allows access only from 10.40.166.87
10.40.166.87
10.40.166.87
Allows access only from 10.40.166.87
ETERNUS CS800 311
10 Configuration