Figure 221: Delete Public Key Page
c. Click Yes.
The "Successfully performed Security action" message appears.
d. Click OK.
The key is removed in the Available SSH Public Keys table.
3. In addition to configuring SSH authentication, the CLI Administrator and view accounts
may also be configured with password authentication.
l Select the Allow login with password check box to enable a password on a CLI
Administrator or CLI Viewer account.
l Clear the Allow login with password check box to disable a password on a CLI
Administrator or CLI Viewer account
Enter the following information:
New Password Enter the new password.
Confirm New Password Enter the new password again to confirm it.
Additional Information
l Passwords can be up to 32 characters. Alphanumeric characters and special
characters are allowed.
l For accounts enabled with both SSH and password authentication, the ETERNUS
CS800 system will first attempt SSH authentication . If there are no keys defined or
no client key matches, the ETERNUS CS800 system will fall back to password
authentication.
4. Click Apply.
Enabling GUI Service Account
Use the GUI password when logging onto the remote management console as a service
account(see "Accessing Remote Management" on page 133).
ETERNUS CS800 345
10 Configuration
To Next Page
Loading...
