Fujitsu ETERNUS CS800 - Page 402

11.4 Receive VTL
1. Select the partition and click Edit.
The Edit Partition Settings page displays (see "Edit Partition Settings Page" on page
402).
Figure 254: Edit Partition Settings Page
2. Select the Enable to receive Cartridge Based replication data check box to enable
Cartridge Based Replication for the partition.
Or clear the Enable to receive Cartridge Based replication data check box to disable
Cartridge Based Replication for the partition.
3. Enter a Sync ID in the box.
The Sync ID is used to identify the source partition that will send replicated data to the
target partition. The Sync ID must be identical to the Sync ID of the source partition on
the source system.
4. Select an Access option:
l Locked - The partition is not allowed to receive new Cartridge Based Replication
data.
l Unlocked - The partition is allowed to receive new Cartridge Based Replication
data.
If a partition configured for Cartridge Based Replication is locked on the target system,
synchronization jobs may fail on the source system.
5. Click Apply.
402 ETERNUS CS800