17.1 Storage Expansion - Entry
Figure 315: ETERNUS CS800 S6 Entry SAS cabling with up to three JX40 S2 enclosures
The SAS IN port of JX40-1 has to be connected to the upper port of the SAS RAID
controller in PCI slot 7 of the server. The SAS OUT port of JX40-1 has to be connected
to the SAS IN port of JX40-2 and so on.
5. If the disks are not already inserted to the ETERNUS JX40 S2: Replace the blank
inserts one after the other by 3.5” 4TB Nearline SAS 7,200 rpm hard disks. The slots you
have to fill up with disks are shown by figure "Disk bays in JX40 used for storage
expansion from 24TB to up to 120TB”.
482 ETERNUS CS800
To Next Page
Loading...
