Fujitsu PRIMERGY RX1330 M4 Upgrade And Maintenance Manual

13.5 Front panel on QRL (10x 2.5-inch HDD) 278
13.5.1 Replacing the front panel on QRL 278
14 Serial interface
283
14.1 Safety notes 283
14.2 Installing the serial interface 283
14.3 Removing the serial interface 286
14.4 Replacing the serial interface 288
15 System board and components 291
15.1 Safety notes 291
15.2 Basic information 291
15.3 CMOS battery 292
15.3.1 Replacing the CMOS battery 292
15.4 Trusted Platform Module (TPM) 295
15.4.1 TPM kit 295
15.4.2 Position of the TPM 295
15.4.3 Installing the TPM 296
15.4.4 Removing the TPM 299
15.4.5 Replacing the TPM 303
15.5 iRMC microSD card 305
15.5.1 Note for embedded Lifecycle Management (eLCM) 305
15.5.2 Installing the iRMC microSD card 305
15.5.3 Removing the iRMC microSD card 307
15.5.4 Replacing the iRMC microSD card 309
15.6 M.2 SSD 310
15.6.1 Installing an M.2 SSD 310
15.6.2 Removing an M.2 SSD 314
15.6.3 Replacing an M.2 SSD 316
Content
Upgrade and Maintenance Manual RX1330 M4

Fujitsu PRIMERGY RX1330 M4 Specifications

General

Chipset	Intel C246
Processor	Intel Pentium, Intel Celeron
Memory Type	DDR4
Memory	Up to 64 GB
Memory Slots	4 DIMM slots
Drive Bays	4 x 3.5-inch or 8 x 2.5-inch
Network	2x 1GbE onboard, optional additional NICs
Power Supply	450W
Form Factor	1U
RAID Controller	optional SAS RAID controller