202 iRMC S2/S3
Power Consumption
Enable Power Monitoring
If you enable this option, power consumption is monitored over time.
I Power monitoring is enabled by default as of Version 3.32 of the
firmware.
I This setting only takes effect on PRIMERGY servers that support
power monitoring.
Ê Click Apply to activate your settings.
Scheduled Power Consumption Configuration
The Scheduled Power Consumption Configuration group allows you to specify in
detail the schedules and modes (operating-system-controlled, best
performance, lowest power consumption) that the iRMC S2/S3 uses to control
power consumption on the managed server.
I The Scheduled Power Consumption Configuration group only appears if you
have enabled the power control mode scheduled in the Power Consumption
Options group.
I Configuration for scheduled power control mode assumes that the
Enhanced Speed Step option has been enabled in the BIOS setup. If this is
not the case, a message to this effect is displayed.
If this message appears even though “Enhanced Speed Step” is
enabled, this may be because:
– The CPU (e.g. low-power CPU) of the server does not support
scheduled power control.
– The system is currently in the BIOS POST phase.
To Next Page
Loading...