Fujitsu Remote Management - Irmc S2;S3-Specific Commands

402 iRMC S2/S3
IPMI OEM Commands supported by the iRMC S2/S3
12.1.2.7 iRMC S2/S3-specific commands
F5 10 - Get System Status
This command returns a variety of internal information on the system such as
the power state, error status, etc.
I The Timestamp is only relevant for evaluating the Notifications Byte.
Request Data - B8 NetFnlLUN: OEM/Group
- F5 Cmd : Command Group Memory
1:3 80 28 00 IANA-Enterprise-Number FTS, LS byte first
4 10 Command Specifier
5:8 Timestamp
Response Data - BC
- F5
1 Completion Code
2:4 80 28 00 IANA-Enterprise-Number FTS, LS byte first
5 System Status (For details see below.)
6 Signaling (For details see below.)
7 Notifications (For details see below.)
8 POST Code
System Status
Bit 7 - System ON
Bit 6 -
Bit 5 -
Bit 4 - SEL entries available
Bit 3 -
Bit 2 - Watchdog active
Bit 1 - Agent connected
Bit 0 - Post State