iRMC S2/S3 89
Using AVR
5.2.1 Using a low bandwidth
In the case of a reduced data transfer rate, you can configure a lower bandwidth
(bits per pixel, bpp) in terms of color depth for your current AVR session (see
page 109).
5.2.2 Parallel AVR sessions
AVR can be used by two user sessions simultaneously. One user has full control
over the server (full-control mode) and the other can only passively observe
keyboard and mouse operation of the server (view only mode).
When AVR is first started, you are initially in view only mode. You will always be
asked if you want to switch to full-control mode. If you decide to switch to full-
control mode and another full-control mode session is already active, the
existing session is switched to view-only mode.
To Next Page
Loading...