Fujitsu Remote Management - 3 Configuring the iRMC S2;S3; 3.1 Configuring the LAN interface of the iRMC S2;S3

iRMC S2/S3 41
3 Configuring the iRMC S2/S3
The following tools are available for configuring the iRMC S2/S3:
– BIOS / TrustedCore / UEFI setup utility (see page 44)
– iRMC S2/S3 web interface (see page 135)
– Server Configuration Manager (see page 347)
This chapter provides you with information about the following topics:
– Configuring the LAN interface of the iRMC S2/S3 using the BIOS /
TrustedCore / UEFI setup utility (see page 44).
– Configuring text console redirection via LAN using the BIOS / TrustedCore /
UEFI setup utility (see page 48).
– Configuring the serial interface of the iRMC S2/S3 using the BIOS /
TrustedCore / UEFI setup utility (see page 57).
– Configuring the iRMC S2/S3 over the web interface (for an overview, see
page 63).
3.1 Configuring the LAN interface of the
iRMC S2/S3
This section describes:
– Requirements for configuring the LAN interface
– Configuring the LAN interface in the BIOS / TrustedCore
®
/ UEFI setup utility
– Testing the LAN interface
I "Spanning Tree" tree for the connection of the iRMC S2/S3 must be
deactivated (e.g. Port Fast=enabled; Fast Forwarding=enabled).