Fujitsu Remote Management - Configuring the Serial Interface of the Irmc S2

58 iRMC S2/S3
Configuring and using the serial interface of the iRMC S2/S3
3.3.1 Configuring the serial interface of the iRMC S2
Ê Call the BIOS / TrustedCore setup utility of the managed server. Do this by
pressing [F2] while the server is booting.
Ê Call the Peripheral Configuration menu to configure the serial port:
Advanced – Peripheral Configuration
Figure 16: Peripheral Configuration menu (as it appears in the TrustedCore setup utility)
Ê Configure the following settings:
Serial 1
Set the value to Enabled.
Serial 1 Address
Accept the first value pair proposed.
Serial Multiplexer
Set the value to iRMC.