Fujitsu Remote Management - Exporting; Importing Configuration Data from; on the

iRMC S2/S3 419
Configuring the iRMC S2/S3 via SCCI and scripted configuration
12.2.1.4 Exporting / importing configuration data from / on the
iRMC S2/S3
The Save iRMC S2/S3 Firmware Settings page of the iRMC S2/S3 web interface
allows you to save (export) the current iRMC S2/S3 configuration data in a
configuration file (.pre). As well, you can import iRMC S2/S3 configuration data
from an existing configuration file (.pre), i.e. load configuration data onto the
iRMC S2/S3 (for details, see section "Save iRMC S2/S3 Firmware Settings -
Save firmware settings" on page 169.)
To import an iRMC S2/S3 configuration, you can alternatively send the
corresponding SCCI command file to the /config URI of the iRMC S2/S3 via the
HTTP POST operation.