Fujitsu Remote Management - Request Data - - 1:3; Response Data - - 1 2:4; IANA-Enterprise-Number FTS, LS Byte First

392 iRMC S2/S3
IPMI OEM Commands supported by the iRMC S2/S3
01 20 - Set Next Power On Time
This command switches on a system at the given time independent of the stored
On/Off times in the Configuration Space.
I The command takes effect only once.
You cancel a “Power On” time previously set with a 01 20 command by
specifying the “Power On” time “0” in a subsequent 01 20 command.
Time (LSB first)
Time (UNIX-specific format) when the system switches on again. Time is
NOT stored in non-volatile memory. Resolution is 1 minute. After the
system has switched on, Time is set to 0 internally.
If Time == 0, the system is not switched on.
Request Data - B8 NetFnlLUN: OEM/Group
- 01 Cmd : Command Group Communication
1:3 80 28 00 IANA-Enterprise-Number FTS, LS byte first
4 20 Command Specifier
5 00 Object ID
6:7 00 00 Value ID
8 04 Data Length
9:12 Time (LSB first) (see below)
Response Data - BC
- 01
1 Completion Code
2:4 80 28 00 IANA-Enterprise-Number FTS, LS byte first