274 iRMC S2/S3
User Management
LDAP Enabled
This option specifies whether the iRMC S2/S3 can access a directory
service via LDAP. Directory service access via LDAP is only possible if
LDAP Enable has been activated.
I If LDAP Enable is checked then the login information (see
page 136) is always transferred with SSL encryption between the
web browser and the iRMC S2/S3.
LDAP SSL Enabled
If you check this option then data transfer between iRMC S2/S3 and the
directory server is SSL encrypted.
I LDAP SSL Enable has no influence on whether or not the
iRMC S2/S3 web interface pages are SSL-protected on opening.
I You should only activate LDAP SSL Enable if a domain controller
certificate is installed.
Disable Local Login
If you activate this option then all the local iRMC S2/S3 user
identifications are locked and only the user identifications managed by
the directory service are valid.
V CAUTION!
If the option Disable Local Login is activated and the connection to
the directory service fails then it is no longer possible to log in at
the iRMC S2/S3.
Always use SSL Login
I This option is only relevant if LDAP is deactivated.
If you activate this option then the HTTP SSL-secured login page is
always used even if LDAP is deactivated. Only if you do not activate
Always use SSL Login and LDAP is deactivated is a mask secured via
Digest Authentication Login used.
To Next Page
Loading...