356 iRMC S2/S3
iRMC S2/S3 firmware (overview)
Firmware selector
The firmware selector specifies the iRMC S2/S3 firmware to be executed. Every
time the iRMC S2/S3 is reset and restarted, the firmware selector is evaluated
and processing branches to the corresponding firmware.
The firmware selector can have the following values:
I Depending on the update variant used, the firmware selector is set
differently after the update.
You can query and explicitly set the firmware selector
– on the iRMC S2/S3 Information page of the iRMC S2/S3 web interface
(see "Running Firmware" on page 166)
or
– using the flash tool (see page 368).
0 Firmware image containing the most recent firmware version
1 firmware image 1
2 firmware image 2
3 Firmware image containing the oldest firmware version
4 Firmware image most recently updated
5 Firmware image that has been updated least recently
To Next Page
Loading...