Fujitsu Remote Management - Page 425

iRMC S2/S3 425
Configuring the iRMC S2/S3 via SCCI and scripted configuration
[-p] <password>
Password for the given Object ID.
Default:1452 (ConfBMCAcctUserPassword)
Supported values:
1273 - ConfAlarmEmailSMTPAuthPassword
[-p] <password>
Password for the given Object ID.
Default: 1452 (ConfBMCAcctUserPassword)
Supported Values:
1452 - ConfBMCAcctUserPassword
1273 - ConfAlarmEmailSMTPAuthPassword
197A - ConfLdapiRMCgroupsUserPasswd
1980 - ConfBMCLicenseKey
iRMC_PWD command line output options
[-b]
Creates the output file as a WinSCU BATCH file.
[-f] <Output File>
Specify the output file name.
Default: iRMC_pwd.txt
Default in Batch mode: iRMC_pwd.pre
Example
You want to generate a .pre file that sets/changes the username to admin
and the password to SecretPassword for the (existing) user with the oid 2.
To achieve this, enter the following command:
iRMC_PWD -o 2 -u admin -p SecretPassword -b
iRMC_PWD will generate a .pre file with the contents shown in figure 226 on
page 426.