Field Description
vider must be entered, e.g. internet.eplus.de for eplus and so
on.
A maximum of 40 characters can be entered. If no APN or an
incorrect APN is entered, a configured GPRS connection will
not function.
11.2 Ethernet Ports
An Ethernet interface is a physical interface for connection to the local network or external
networks.
The Ethernet ports ETH1 to ETH4 are assigned to a single logical Ethernet interface in ex
works state. The logical Ethernet interface ! is assigned, and preconfigured with IP
Address and Netmask .
The logical Ethernet interface ! is assigned to the ETH5 port and is not precon-
figured.
Note
To ensure your device can be reached, when splitting ports make sure that Ethernet
interface ! is assigned - with the preconfigured IP address and netmask - to a
port that can be reached via Ethernet. If in doubt, carry out the configuration using a
serial connection via the Console interface.
ETH1 - ETH4
The interfaces can be used separately. They are logically separated from each other, each
port being assigned the desired logical Ethernet interface in the Ethernet Interface Selec-
tion field of the Port Configuration menu. For each assigned Ethernet interface, another
interface is displayed in the list in the LAN->IP Configuration menu, and a completely in-
dependent configuration of the interface is made possible.
ETH5
By default, the logical Ethernet interface ! is assigned to the ETH5 port. The configur-
ation options are the same as those for the ports ETH1 - ETH4.
11 Physical Interfaces Funkwerk Enterprise Communications GmbH
124 bintec Rxxx2/RTxxx2
To Next Page
Loading...