Field Description
during compression.
The function is enabled with #/.
The function is disabled by default.
Alive Check Select whether and how IPSec heartbeats are used.
A bintec IPSec heartbeat is implemented to determine whether
or not a Security Association (SA) is still valid. This function
sends and receives signals every 5 seconds, depending on the
configuration. If these signals are not received after 20 seconds,
the SA is discarded as invalid.
Possible values:
• %: Your device sends and expects no heartbeat. Set
this option if you use devices from other manufacturers.
• @#& =,% /)": Your device expects a
heartbeat from the peer but does not send one itself.
• -: Your device expects no heartbeat from the peer, but
sends one itself.
• @#& - L=,%": Your device expects a
heartbeat from the peer and sends one itself.
• 0%: Automatic detection of whether the remote ter-
minal is a bintec device. If it is, Heartbeat Both (for a remote
terminal with bintec) or None (for a remote terminal without
bintec) is set.
Propagate PMTU Select whether the PMTU (Path Maximum Transfer Unit) is to
be propagated during phase 2.
The function is enabled with #/.
The function is enabled by default.
18.1.4 XAUTH Profiles
In the XAUTH Profiles menu a list of all XAUTH profiles is displayed.
Extended Authentication for IPSec (XAuth) is an additional authentication method for IPSec
tunnel users.
18 VPN Funkwerk Enterprise Communications GmbH
336 bintec Rxxx2/RTxxx2
To Next Page