Chapter 8 Access and configuration
This chapter describes all the access and configuration options.
8.1 Access Options
The various access options are presented below. Select the procedure to suit your needs.
There are various ways you can access your device to configure it:
• Via your LAN
• Via the serial interface
• Via an ISDN connection
8.1.1 Access via LAN
Access via one of the Ethernet interfaces of your device allows you to open the Funkwerk
Configuration Interface in a web browser for configuration purposes and to access your
device via Telnet or SSH.
Caution
If you carry out the initial configuration with the Funkwerk Configuration Interface ,
this can result in inconsistencies or malfunctions, as soon as you carry out additional
settings using other configuration options. Therefore, it is recommended that the con-
figuration is continued with the Funkwerk Configuration Interface . If you use SNMP
shell commands, continue with this configuration method.
8.1.1.1 HTTP/HTTPS
With a current web browser, you can use the HTML interfaces to configure your device. For
this, enter the following in your web browser's address field:
• ,677
or
• ,&677
Funkwerk Enterprise Communications GmbH
8 Access and configuration
bintec Rxxx2/RTxxx2 49
To Next Page
Loading...