Type of connection Possible types of configuration
Serial connection Shell command
The following section describes how to configure your device using the Funkwerk Config-
uration Interface.
Note
To change the device configuration, you must log in with the user name . If you
do not know the password, you cannot make any configuration settings. This applies to
all types of configuration.
8.3.1 Funkwerk Configuration Interface
The Funkwerk Configuration Interface is a web-based graphic user surface that you can
use from any PC with an up-to-date web browser via an HTTP or HTTPS connection.
You can use the Funkwerk Configuration Interface to carry out all configuration tasks
easily. It is integrated in your device and is available in English. If required, other languages
can be downloaded from the download areaSoftware &Configuration on page 486 of
www.funkwerk-ec.com and installed on your device. To do this, proceed as described in
Options on page 486.
The settings you make with the Funkwerk Configuration Interface are applied with the
OK or Apply button of the menu, and you do not have to restart the device.
If you finish the configuration and want to save your settings so that they are loaded as the
boot configuration when you reboot your device, save these by clicking the Save configur-
ation button.
You can also use the Funkwerk Configuration Interface to monitor the most important
function parameters of your device.
Funkwerk Enterprise Communications GmbH
8 Access and configuration
bintec Rxxx2/RTxxx2 57
To Next Page
Loading...