Funkwerk R1202 - Page 140

Field Description
to the numbering of the Ethernet ports on the back of the
device.
Ethernet Interface Se-
lection
Assign a logical Ethernet interface to the switch port.
You can select from five interfaces, ! to !. In the ba-
sic setting, switch ports 1-4 are assigned to interface !
and switch port 5 is assigned to interface !
Configured Speed /
Mode
Select the mode in which the interface is to run.
Possible values:
• 5// 0$ (default value)
• 0  #,& /)
• 0  #,& /)
• 0  #,& /)
• 0  #,& 7 5// 1,/=
• 0  #,& 7 @/ 1,/=
• 0  #,& 7 5// 1,/=
• 0  #,& 7 @/ 1,/=
• 5=  #,& 7 5// 1,/=
• 5=  #,& 7 5// 1,/=
• 5=  #,& 7 @/ 1,/=
• 5=  #,& 7 5// 1,/=
• 5=  #,& 7 @/ 1,/=
• * : The interface is created but remains inactive.
Current Speed / Mode Shows the actual mode and actual speed of the interface.
Possible values:
•  #,& 7 5// 1,/=
•  #,& 7 5// 1,/=
•  #,& 7 @/ 1,/=
•  #,& 7 5// 1,/=
•  #,& 7 @/ 1,/=
• 1
11 Physical Interfaces Funkwerk Enterprise Communications GmbH
126 bintec Rxxx2/RTxxx2