Field Description
IP Address Mode Select whether your device is to be assigned a static IP address
or whether it should be assigned this dynamically.
Possible values:
• 0&& (default value): Your device is automatic-
ally assigned a temporarily valid IP address from the provider.
• -% : You enter a static IP address.
Default Route Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with #/.
The function is enabled by default.
Create NAT Policy Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is enabled with #/.
The function is enabled by default.
Local IP Address Only for IP Address Mode = -%.
Assign an IP address from your LAN to the PPT interface, which
is to be used as your device's internal source address.
Route Entries Only if IP Address Mode = -%
Define other routing entries for this PPTP partner.
Add new entries with Add.
• ; 0&&: IP address of the destination host or
network.
• *&: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
• (%: The lower the value, the higher the priority of the
route (range of values ... ). The default value is .
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu
17 WAN Funkwerk Enterprise Communications GmbH
270 bintec Rxxx2/RTxxx2
To Next Page
Loading...