Field Description
Possible values:
• -% (default value): You enter a static IP address.
• 0&&: Only for Connection Type = 2*-.
Your device dynamically assigns an IP address to the remote
terminal.
• 0&&: Only for Connection Type = 204. Your
device is dynamically assigned an IP address.
Default Route Only for IP Address Mode = 0&&
and -%
Select whether the route to this connection partner is to be
defined as the default route.
The function is enabled with #/.
The function is disabled by default.
Create NAT Policy Only for IP Address Mode = 0&&
and -%
Specify whether Network Address Translation (NAT) is to be ac-
tivated for this connection.
The function is enabled with #/.
The function is disabled by default.
IP Assignment Pool
(IPCP)
Only for IP Address Mode = 0&&
Select IP pools configured in the WAN->Internet + Dialup->IP
Poolsmenu.
Local IP Address Only for IP Address Mode = -%.
Enter the WAN IP address of your device.
Route Entries Only for IP Address Mode = -%.
Enter Remote IP Address and Netmask of the LANs for L2TP
partners and the corresponding Metric. Add new entries with
Add.
18 VPN Funkwerk Enterprise Communications GmbH
350 bintec Rxxx2/RTxxx2
To Next Page