9. E-MAIL BY PC
9-4
9.3 Function Settings
For network setting, consult your shipboard LAN administrator.
9.3.1 How to set IP address and subnet mask
Turn off DHCP from the [Network] menu to set IP address or subnet mask.
Also, if another device in the network shares the same IP address with the FELCOM
18, the message "Duplicate IP address detected." appears. If it is necessary to change
the IP address of the FELCOM 18, follow the procedure below.
1. Press the F8 and 1 keys to show the [System Setup] menu.
2. Select [Network Setup] then press the Enter key.
3. Select [Network] then press the Enter key.
4. [IP Address] is selected; press the Enter key.
5. Enter IP address then press the Enter key.
6. Select [Subnet Mask] then press the Enter key.
7. Enter subnet mask then press the Enter key.
8. Press the Esc key to show the [Update] window.
9. [Yes] is selected; press the Enter key. If you changed the IP address a message
asks you to restart the FELCOM. Press the Esc key to restart the FELCOM. If only
the subnet mask setting was changed go to the next step.
10. Long-press the Esc key to return to the standby display.
Network
IP Address 172. 31. 16. 1
Subnet Mask 255. 255. 0. 0
DHCP OFF
Gateway . . .
To Next Page
Loading...
Need help?
General
