4. FILE OPERATIONS
4-8
4.4.2 How to switch between files
You can switch between files by pressing the 9 key (Change Window) on the [Edit]
menu ([F2]), or pressing Alt+V on the editor screen.
4.4.3 How to open a file when both working areas are occupied
If both working areas in the memory are occupied when you attempt to open a file, you
are asked "Save this message?" for the active file.
1. To save the file, press the Enter key to show the [Save] window. If you don’t need
to save the file, select [No], press the Enter key then go to step 4.
2. To enter the same file name as the edited file, press the Enter key.
3. [Yes] is selected; press the Enter key.
4. Select the file to open then press the Enter key.
4.5 How to Save a File Under a New Name
1. Open a file referring to section 4.4.1.
2. Edit the file.
3. Press the F1 key then the 3 (Close) or 4 (Save) key as applicable.
4. For [Close], press the Enter key.
5. Press the BackSpace key to delete the original file name. Enter a file name.
6. Press the Enter key.
Note: Should you decide to save the file under the original name, skip step 5. The
message "File already exists. Overwrite?" appears. Overwrite the file by pressing
the Enter key, or select [No] then press the Enter key to escape.
4.6 How to Print Files
You can print out a hard copy of files stored.
1. Press the F1 and 7 keys to show the list of files. (If necessary, switch drives; C for
SD card, A for the internal memory.)
2. Select a file. To get a partial view of a file, tap the Spacebar. Press the Esc key
to escape.
3. Press the Enter key to print the file.
[F2]
9: Change Window
or [ALT] + [V]
How to alternate display of files in working area 1 and 2.
FURUNOABC
1
2
To Next Page
Loading...
Need help?
General
