5. INMARSAT COMMUNICATIONS
5-6
Display log printout example (Confirmation ON, delivery status not delivered)
Depending on traffic, it may take at least 15 minutes to receive confirmation.
Status of sent message
The terminal unit displays the status of messages you have sent as follows:
Message send failed. This appears if the message could not be sent because of
technical reasons such as satellite malfunction, signal degradation, or no reply from
the LES. Try to send the message again.
Message send rejected. This appears when the LES rejects the message because
of non-technical reasons such as unpaid subscriber’s fee.
Message send pending. This appears when the circuits at the LES are busy. Your
message will be sent once a circuit becomes clear.
How to send a message to a station not registered on the station list
1. Prepare message on the screen.
For e-mail or SMS, set [Text Mode] in the [Editor Setup] menu to [Ascii]. See
section 4.2.3.
For e-mail attachment, prepare the attachment and save it to an SD card or the
internal memory. SMS messages over 160 characters in length are sent in parts.
2. Press the F3 and 1 key to display the [Transmit Message] menu.
Sent Message but not delivered
DELIVERY STATUS NOT RECEIVED (in case of timeout)
Message File : 00FOX.TXT Message Size : 277 characters
LES : Stratos M.N. Date : 02-03-10
Priority : Normal Time : 06:06 (UTC)
Destination : TELEX/MES (Prefixed) 00111222222222222222 (IA5)
1. Transmit Message
2. Cancel
3. Request Delivery Status
Transmit Message
Normal
Size 24
TELEX/MES
82
65-2111
303 (KDDI)
ON
00:00
Immediate
IA5
Priority
Message File
Station Name
Destination Type
Prefix Code
Country/Ocean Code
Destination
Modem Type
Address
Subject
Attach File
LES ID
Option
Confirmation
Send Delay
Delivery Delay
Code
[ TRANSMIT ]
To Next Page
Loading...
