FUTABA 4PV - Installation; Receiver and Servo Connections

S.BUS2
CH3
CH2
CH1
CH4
Receiver
Switch
To Battery
CH4 servo
CH3 servo
Throttle servo
Steering servo
29
Installation
Connect the receiver and servos as shown below. Connect and install the receiver and ser-
vos in accordance with
"
I
nstallation Safety Precautions
"
on the next page.
7KH¿JXUHVKRZQEHORZLVDQH[DPSOH7KHPHWKRGRIFRQQHFWLQJWKHPRWRUFRQWUROOHUWR
WKHPRWRUDQGEDWWHU\GHSHQGVRQWKHPRWRUFRQWUROOHUXVHG3XUFKDVHWKHPRWRUFRQWUROOHU
and servos separately. The receiver also depends on the set.
Installation When An Electronic Speed Control Is Used
Installation For Gas Powered Models
Installation
Receiver and Servo Connections
4PV-Eng-05-Instllation-P29-32.indd 29 2016/08/05 8:52:03