FUTABA 4PV - Data Transfer MDL TRANS

Connect the communication
port of both T4PV with the
optional DSC cord.
Communication port
DSC cord for T4PK (option)
(MDL TRANS screen)
Pres
s
(HOME screen)
(MENU 1 )
(MENU 2 )
Pres
s
(MENU 3 )
Pres
s
Select
" MDL TRANS "
105
Function
Data Transfer "MDL TRANS"
This function copies the model memory data of one T4PV to another T4PV. Connect the
communication port of both T4PVs with the optional DSC cord for T4PK.
Note: If the T4PV battery voltage drops, the display switches to low battery display. There-
fore, use this function when there is ample battery capacity remaining.
Note: Since the receiving side writes the new contents of the currently selected model mem-
ory, always check the model number before executing this function.
Data is not interchangeable with another type of transmitter.
(Preparation)
- Connect the communication port of both transmitters with the
optional DSC cord for T4PK.
- Turn on the power of both T4PVs. Select the model number of
the transfer side and the receiving side with the model select
function (page 46).
1
Display the data transfer function screen in the above manner.
Using the Data Transfer function
Data Transfer "MDL TRANS"
Display to
"
MDL TRANS
"
screen using the following method:
4PV-Eng-08-3-Function-P93-128.indd 105 2016/08/05 10:13:20