FUTABA 4PV - Servo Reverse REVERSE

Setting item
STR :Steering (1st channel)
THR :Throttle (2nd channel)
CH3 :3rd channel
CH4 :4th channel
Move the cursor to "STR, THR,
CH3 and CH4" with the (JOG)
button.
Pres
s
Pres
s
Pres
s
(HOME screen)
(MENU 2 )
(MENU 3 )
(REVERSE screen)
(MENU 1 )
Select
"REVERSE"
Select button
- Select with the (+) or (-) but-
tons.
Or use the jog dial left or right
to set the normal, reverse op-
erations.
50
Function
Servo Reverse "REV"
However, when the position set by trim or subtrim shifts from
the center, the center becomes the opposite side.
Servo Reverse "REVERSE"
(All channel)
This function reverses the direction of operation of the servos related to transmitter steer-
ing, throttle, and channels 3/4 operation.
(Preparation)
- Select the channel to be set by moving the (JOG) button up or
down.
1
(Servo reverse setting)
Use the (+) or (-) button to reverse the servo op-
eration direction.
NOR/REV can also be set by moving the (JOG)
button left or right.
(Each channel can be set similar.)
Servo reverse function setting
Display to
"
REVERSE
"
screen using the following method:
2
When finished with setting, return to the MENU screen by
pressing the (END) button.
4PV-Eng-08-1-Function-P45-69.indd 50 2016/08/05 9:35:32