GE AquaTrans AT600 - 5.1.2.1 E1: Low Signal Error; 5.1.2.2 E2: Sound Speed Error; 5.1.2.3 E3: Velocity Range Error; 5.1.2.4 E4: Signal Quality Error

Chapter 4. Initial Setup and Programming
78 AquaTrans™ AT600 User’s Manual
4.7.5.2 Entering a Special Transducer
Select Wedge Angle and press [√]. The following screen opens.
Press
[] again, and a screen similar to the following opens.
Use the [] or [] key to select a specific digit, then use the [] or [] key
to change that digit as required. After all digits are correct, press
[] to
save. Then, press [
] to return to the previous screen.
Select
Wedge SNSD and press [√]. The following screen opens.
Special Transducer
Frequency
Wedge SNSD
Time Wedge
Wedge Angle
Wedge Angle
Wedge Angle
42
Wedge Angle
4
2
]MOVE
]UNDO [ ]SAVE
]
]
]MODF
[
Special Transducer
Frequency
Wedge Angle
Wedge SNSD
Time Wedge