Appendix D: Troubleshooting
Service Mode (Application Software 1.0.9 and Earlier)
D-4 Service Manual
Flow control None
Click OK
6. Boot Warmer into Service Mode SW if not already.
7. Press Enter on your computer.
8. Type help and press enter to see available commands Note: The LOGS command will display 6 log types
using the following parameters: POW_UP, BUT_PUSH, ALARM, SILENCE, SYSFAIL, STATE, CF
Note: Typing LOGS will capture all data. Data transfer may take up to 15 minutes.
D.1.5 File Capture
1. To capture into a file, click on Transfer/Capture Text and enter a path and file name in the resulting
dialog box.
2. Click Start to start your capture.
To Next Page
Loading...
