GE PANDA Service Manual

Chapter 6: Illustrated Parts
Electronics Enclosure
6-4 Service Manual
6.2 Electronics Enclosure
FIGURE 6-3. Electronics Enclosure
1. Rear enclosure cover (includes labels)........M1118330
2. Keps nut, M3............................................................M1074118
3. Standoff, M3 8 x 18...............................................M1076053
4. Split ring washer,
M3 X 3.1ID, 0.8.............................................. 6600-0713-402
5. Line filter....................................................................M1107967
6. Card guide, 4.5........................................................M1079766
7. Control board........................See Table 6-1 on page 6-5.
Lithium ion battery*.............................................M1121133
8. Probe panel interface board......................2065772-001
9. Screw M3 X 8 Btn Hd.................................6600-0706-405
10. Washer, M3 X 3.2 ID, 0.5...........................6600-0712-402
11. LCD Display............................See Table 6-1 on page 6-5.
2
1
3
4
20
21
6
7
5
2
8
18
17
13
14
12
22
23
16
11
15
10
4
9
2
2
19
4
9
10

GE PANDA Specifications

General

Type	Infant Warmer
Manufacturer	GE Healthcare
Control Modes	Manual, Servo
Integrated Scale	Yes
SpO2 Monitoring	Optional
Bed Tilt	Yes
Heater Type	Ceramic
Alarms	Power Failure
Power Requirements	100-240 VAC, 50/60 Hz
Model	PANDA
Resuscitation Options	Optional
Skin Temperature Probe Accuracy	±0.3°C