GE PANDA Service Manual

Appendix E: Installing Wall Mount Units
Enclosure Dimensional Specification
Service Manual E-15
FIGURE E-11. Schematic Showing Unobstructed Area Access During Use
Note 1: Confirm that the caregiver has unobstructed access to this region during warmer operation.
Actual dimensions are facility specific and, therefore, must be determined by the facility prior to
warmer operation.
Note 2: For repairs, the warmer needs to be removed from the wall bracket and then re-installed on the
bracket. Make sure to provide sufficient spacing in the shaded area to give the service
technician unobstructed access to the two bracket screws on each left-rear and right-rear sides
of the warmer unit.

GE PANDA Specifications

General

Type	Infant Warmer
Manufacturer	GE Healthcare
Control Modes	Manual, Servo
Integrated Scale	Yes
SpO2 Monitoring	Optional
Bed Tilt	Yes
Heater Type	Ceramic
Alarms	Power Failure
Power Requirements	100-240 VAC, 50/60 Hz
Model	PANDA
Resuscitation Options	Optional
Skin Temperature Probe Accuracy	±0.3°C