Operation
Printed in U.S.A. 95 50940411/G0219
Alternate Transport Mode Cancel
Limp modes are canceled if any of the following
occur:
• The parking brake is activated using the switch
on the control panel.
• The operator leaves the seat.
• The arm rests/safety bars are raised.
• The cab door is opened.
• The engine is shut down.
When limp mode is canceled through any one of
these actions, the drive system will remain disabled
until the error condition is corrected or limp mode is
re-activated.
Backup Alarm
The backup alarm (R, Fig. 87) is installed inside the
rear door.
The backup alarm emits a tone whenever the drive
system is operated in reverse.
Do not rely exclusively on the backup alarm to
alert others. Make sure that nobody is within the
work area when traveling in reverse.
Fig. 87 – Optional Backup Alarm
Later Machines
Early Machines
R
To Next Page
Loading...
Need help?
General
