Operation
Printed in U.S.A. 73 50940411/G0219
Closing the Door from the Inside:
a. With the arm rests down, pull the door down
and inward using large handles (D, Fig. 49)
on the fold-up door.
b. Continue to pull the door down until it
latches against the cab.
Opening the Door from the Inside:
a. Pull the two smaller handles (B, Fig. 48) on
the inside of the door inward and then lift up.
b. Push the door up to the ceiling until it
latches.
Seat and Armrest/Joystick Console
Adjustment
Adjust the operator’s seat according to “Operator’s
Seat” on page 61.
Adjust the armrest/joystick position according to
“Armrest/Joystick Console Adjustment” on
page 63.
Never adjust the seat and/or the armrest/
joystick consoles when the machine is in
operation. Adjust the seat and/or the armrest/
joystick consoles only when the machine is
stopped and the parking brake is applied.
All controls must be within easy reach. The
operator must be able to move the throttle pedal
and the control joysticks through the complete
range of motion.
After adjustments, make sure levers for the seat
and/or the armrest/joystick console adjustments
are fully engaged before using the machine.
Seat Belt
Fasten the seat belt around your hips and waist and
insert tongue (A, Fig. 50) into clasp (B) until it
clicks securely in place. Slack in the seat belt should
automatically retract into seat belt spool (K).
Never operate the machine without the seat belt
fastened. Repair or replace any damaged seat
belt and lock parts before operation.
If the seat belt spool does not retract the slack
in the seat belt, have it serviced immediately. Do
not operate the machine if the seat belt is not
fastened and working properly.
NOTE: Unfasten the seatbelt by pressing button
(C).
D
Fig. 49 – Closing the Door from the Inside
B
A
D
K
Fig. 50 – Seat Belt
To Next Page
Loading...
