Operation
Printed in U.S.A. 71 50940411/G0219
Before Operation
Cab Entry and Exit
Always perform the “Mandatory Safety
Shutdown Procedure” on page 20 before exiting
the machine.
Use only step (S, Fig. 42) and handles (R) on the
machine when entering/exiting the cab. Keep
the steps and the handles clean to ensure a
secure hold at all times. Never use the control
joysticks as hand holds. Remove dirt (oil,
grease, earth, snow and ice) from handles (R),
steps (S) and your shoes before entering the
cab.
Always face the machine when entering/exiting.
When entering/exiting the cab, open the door
fully to the locked position and check that it
does not move (machines equipped with cab
door).
Do not jump on or off the machine. Never climb
onto or exit a moving machine.
Opening/Closing the Cab Door
Operate the door latch outside the cab using button
(Z, Fig. 43) on the exterior door handle.
Lock/unlock the door using the ignition key in the
key slot in button (Z).
Operate the door latch inside the cab using lever (Y,
Fig. 44) located along the interior door frame.
R
S
Fig. 42 – Cab Entry/Exit Handles/Steps
R
Fig. 43 – Cab Exterior Door Handle
Z
Fig. 44 – Cab Interior Door Lever
Early Machines
Later Machines
Y
To Next Page
Loading...
