Gehl RT210 User Manual

Maintenance
50940411/G0219 128 Printed in U.S.A.
Changing Engine Oil and Filter
Change the engine oil and filter after the first 50
hours of use, and every 250 hours thereafter.
1. Park the machine on a level surface.
2. Perform the “Mandatory Safety Shutdown
Procedure” on page 20.
3. Wait until the engine has cooled, but is not
completely cold. Oil will drain faster and more
completely if it is warm.
4. Open the engine cover according to “Engine
Access” on page 126.
5. Remove hardware (M, Fig. 127) securing engine
drain plug access panel (N). Remove panel to
access engine oil drain plug (O).
NOTE:
On Model RT250, and Models RT175
and RT210 with oil filters located on the side of
the engine, oil filter (D, Fig. 128) is accessed
through the drain plug access hole (Q, Fig. 127).
6. Position a waste oil collection container under
the engine oil drain plug to catch draining oil.
IMPORTANT:
Dispose waste engine oil according
to environmental laws, or take to a recycling center
for proper disposal. DO NOT pour waste engine oil
onto the ground or down a drain.
7. Remove drain plug (O) from the engine oil pan
and allow the oil to drain into the waste oil
collection container.
NOTE:
On early Models RT175 and RT210, oil
drain plug (O) is located on the side of the oil pan.
8. Remove oil filter (D, Fig. 128), using a filter
wrench if necessary. Carefully clean the filter
head mounting surface with a clean cloth.
NOTE:
On Model RT250, and Models RT175
and RT210 with oil filters located on the side of
the engine, oil filter (D, Fig. 128) is accessed
through the drain plug access hole (Q, Fig. 127).
Fig. 127 – Engine Oil Drain Plug (Later Models
RT175/RT210 Shown; RT250 Similar)
O
M
N
Q
Fig. 128 – Engine Oil Filter
Model RT250
D
Models RT175/RT210
D

Gehl RT210 Specifications

General

Rated Operating Capacity	2, 100 lbs
Engine Make	Yanmar
Tipping Load	6000 lbs
Displacement	202 cu in
Hydraulic Pressure	3335 psi
Width	72 in