Maintenance
Printed in U.S.A. 129 50940411/G0219
9. Apply a coating of clean oil on the new oil filter
gasket. Install the filter and tighten 3/4 rotation
past the point where the gasket contacts the filter
head.
10. Re-install and tighten the drain plug.
11. Clean the area around oil fill cap (G, Fig. 129).
Remove oil fill cap (G) and add the
recommended type and amount of oil. See
“Fluids/Lubricants Types and Capacities” on
page 35. Replace and tighten oil fill cap (G) after
the oil is added.
NOTE:
Oil capacity listed is approximate.
Always verify proper oil level with the engine oil
dipstick.
IMPORTANT: Do not over-fill the engine with oil.
Damage could result.
12. Start the engine and let it run for several minutes
at low idle. Watch for leaks at the oil filter and
drain plug. Stop the engine and wait for it to
cool.
13. Check the oil level. Add oil if necessary until the
oil level is at the “Full” mark on the dipstick
(Fig. 126).
14. Replace engine drain plug access panel (N, Fig.
130). Secure with hardware (M).
C
RT175 and RT210 with Tier 4 Engines
RT175 and RT210 with interim Tier 4 Engines
RT250
C
C
G
G
G
Fig. 129 – Engine Oil Fill
Fig. 130 – Engine Oil Drain Access Panel
M
N
To Next Page
Loading...
Need help?
General
