Gehl RT210 User Manual

Operation
50940411/G0219 80 Printed in U.S.A.
IMPORTANT: Perform stationary regeneration as
soon as possible when the stationary regeneration
request screen displays. Postponing stationary
regeneration for extended periods will cause signifi-
cant reduction in engine power and will force pre-
mature DPF filter core replacement.
To proceed with stationary regeneration:
1. Park the machine in a safe, well-ventilated loca-
tion away from flammable materials.
2. The following conditions need to be met before
stationary regeneration continues:
a. Apply the parking brake using the parking
brake switch or by lifting the safety bars/arm
rests. A checkmark (M, Fig. 57) is displayed
next to the parking brake icon in the middle
of the stationary regeneration request screen.
b. When engine coolant has reached operating
temperature (above 140° F / 60° C), a
checkmark (O) is displayed next to the
coolant temperature icon.
c. Place throttle controls to the lowest speed
setting. A checkmark (P) is displayed next to
the slow engine speed icon when the engine
is running at low idle.
3. When all three checkmarks (M, O & P) are
displayed on the stationary regeneration request
screen, press and hold the interface button on the
multi-function display until the DPF Stationary
Regeneration In Progress screen (Fig. 58) is
displayed.
4. Stationary regeneration progress is displayed in
the center (X, Fig. 58) of the DPF Stationary
Regeneration In Progress Screen.
5. When stationary regeneration completes, the
display returns to the coolant temperature status
screen (Fig. 59).
NOTE:
Stationary regeneration can be interrupted
at any time by releasing the parking brake,
advancing the throttle, or stopping the engine.
Stationary regeneration must start again from the
beginning if it is interrupted.
NOTE: Stationary regeneration takes
approximately 25-30 minutes. When stationary
regeneration completes, the display returns to the
home status screen.
CAUTION
It is not necessary to stay in the machine during
stationary regeneration. Keep the machine
under observation while regeneration is in
progress in case of malfunction. Keep
bystanders away from the machine while
regeneration is in progress.
Fig. 57 – Stationary Regeneration Request
Screen – Parking Brake On.
M
O
P
Fig. 58 – DPF Stationary Regeneration In
Progress Screen
X
Fig. 59 – Coolant Temperature Status Screen

Gehl RT210 Specifications

General

Rated Operating Capacity	2, 100 lbs
Engine Make	Yanmar
Tipping Load	6000 lbs
Displacement	202 cu in
Hydraulic Pressure	3335 psi
Width	72 in