Getinge Maquet PowerLED II User Manual

4
Use
Daily inspections before use
44 / 116
Maquet PowerLED II
IFU 01811 EN 10
Fig.38: Stability and drift
Stability and drift of the system
1. Operate the device, making several move-
ments in order to swivel the extension
arms, the spring arms and the lightheads.
Ø The entire system should move easily
and smoothly.
2. Place the system in various positions.
Ø The entire system should remain in the
selected position, without any drift.
3. If a problem is noted, contact technical
support.
Fig.39: Spring arm positioning
Spring arm positioning
1. Place the spring arm in its lowest position,
horizontally and finally in its highest posi-
tion.
2. Check that the spring arm remains in each
of these positions.
3. If a problem is noted, contact technical
support.
Fig.40: Silicone caps and lighthead cover
Silicone caps and lighthead cover
1. Check that the lighthead caps are in the
proper position and in good condition.
2. Check that the lighthead cover are in the
proper position and in good condition.
3. If a problem is noted, contact technical
support.

Getinge Maquet PowerLED II Specifications

General

Brand	Getinge
Model	Maquet PowerLED II
Category	Medical Equipment
Language	English