GretagMacbeth Spectroeye - Equipment Firmware

1
SpectroEye™ 11
1.1.2.2 Equipment firmware
The firmware for the SpectroEye has a modular configuration.
This means that the range of functions must be configured
according to requirements when the device is purchased,
and that possible supplementary functions can be added
at any time.
• The basic instrument is equipped with the following
standard measurement functions:
Densitometry - Density
Spectrum - Reflection spectrum
Colorimetry - CIELAB with CIE L*a*b*,
CIE L*C*h (a*b*) and E CIELAB
• The following additional functions may be purchased
and enabled:
Densitometry - All densities
- Dot gain
- Dot area
- Contrast
- Trapping
- Hue error
- Greyness
- Print characteristic
- Printing plate
- Auto function
Spectrum - Density spectrum
Colorimetry - CIE XYZ, CIE xyY
- CIELUV with CIE L*u*v*,
CIE L*C*h (u*v*) and E CIELUV
- LABmg, LCHmg and Emg
- Hunter Lab and E Hunter Lab
- Reflection factor RxRyRz
Color difference - Metamerism, E*94, E CMC,
E FMCII
Dye strength - Absolute (K/S) and relative (DS)
White- and Yellowness - W CIE, W E313, W Berger,
W Stensby, ISO Brightness R457,
Y E313, Y D1925, T CIE
Special functions - Best Match
Color guides - Pantone
®
Color Formula Guide,
HKS E/K/N/Z, TOYO Color Finder,
DIC Color Guide
Security - Setting protection
- Multiple users
Indications regarding basic and
supplementary functions are as
per Nov. '98. Modifications may
be made at any time.
Contact your GretagMacbeth dealer
who will be happy to inform you
of any innovations or variations.
When reading this manual, check
if the description of these
supplementary functions is
indicated by the puzzle symbol.
This will save you the time of reading
sections regarding functions which
are not applicable to your instrument.
1 • Set-up